Dnia 2013-02-23, o godz. 13:30:39
jędrek <w...@p...onet.pl> napisał(a):

> Z tego co pamiętam oba takie same dyski (inne sztuki) pracujące na
> jeszcze starszej płycie Abit KG-7 nie miały tej przypadłości -
> zapięte tak samo na jednej taśmie. Talerzy nigdy nie zatrzymywały aż
> do czasu wyłączenia kompa.

Takie zatrzymanie to może być ustawienie albo BIOS albo nawet systemu
operacyjnego. Z instrukcji tego dysku:
http://www.seagate.com/support/disc/manuals/ata/1004
02369a.pdf

The drive provides programmable power management to provide greater
energy efficiency. In most systems, you can control power management
through the system setup program. The drive features the following
power-management modes:
o Active mode The drive is in Active mode
during the read/write and seek operations. o Idle mode
The buffer remains enabled, and the drive accepts all commands and
returns to Active mode any time disc access is necessary.
o Standby mode
The drive enters Standby mode when the host sends a Standby Immediate
command. If the host has set the standby timer, the drive can also
enter Standby mode automatically after the drive has been inactive for
a specifiable length of time. The standby timer delay is established
using a Standby or Idle command. In Standby mode, the drive buffer is
enabled, the heads are parked and the spindle is at rest. The drive
accepts all commands and returns to Active mode any time disc access is
necessary. o Sleep mode The drive enters Sleep mode after receiving a
Sleep command from the host. In Sleep mode, the drive buffer is
disabled, the heads are parked and the spindle is at rest. The drive
leaves Sleep mode after it receives a Hard Reset or Soft Reset from the
host. After receiving a reset, the drive exits Sleep mode and enters
Standby mode with all current translation parameters intact. o Idle and
Standby timers Each time the drive performs an Active function (read,
write or seek), the standby timer is reinitialized and begins counting
down from its specified delay times to zero. If the standby timer
reaches zero before any drive activity is required, the drive makes a
transition to Standby mode. In both Idle and Standby mode, the drive
accepts all commands and returns to Active mode when disc access is
necessary. Power mode Heads Spindle Buffer Active Tracking Rotating
Enabled Idle Tracking Rotating Enabled Standby Parked Stopped Enabled
Sleep Parked Stopped Disabled

> Pozostałe szpilki 5-6, 7-8 to jakieś konfiguracje serwisowe? Czy po
> prostu dają gniazdo 8 szpilkowe bo takie mają w standardzie do dysków?

Ten model ma [piny 5-8 OIDP nieaktywne. W innych modelach za ich
pomocą można było np. ustawić limit pojemności wymagany przez starsze
systemy operacyjne.

Zdrówko